FAQs

Please bear with us as we are updating our FAQ page. If you have any questions please contact us below or by email at sales@stanhopebelts.com.

 

Straps  Will your track straps work with other track buckles? Most likely.

Will other track straps work with your buckles? Possibly.

 

How to ATTACH, DETACH, FASTEN, UNFASTEN and CUT the strap:

ATTACH the strap to the buckle:

1- Open the clasp and slide the back end of the strap (back side up) into the clasp.

2- Firmly press the clasp onto the strap to close.

DETACH the strap from the buckle:

1- Remove the plastic release from the buckle and place one of its ends into the slot in the clasp. Lift the release (let it bend) to open the clasp.

2- Slide out the strap.

FASTEN the strap and the buckle:

Place the strap around your waist, then slide the strap into the buckle as shown till it is comfortably snug.

UNFASTEN the strap and the buckle:

1- Slide the plastic release ½ inch over to the other side of the buckle as shown.

2- Slide out the strap.

CUT the strap to fit:

1- Attach the uncut strap to the buckle and fasten the strap till it fits comfortably in position. The strap will likely be longer than desired.

2- Measure how far from where the tip is to where you would like the tip to end up. Add 3 inches extra for safety and detach the strap from the buckle. Then cut that amount off the end of the strap with sharp scissors.

3- Attach the strap again to the buckle.

4- You may want the strap slightly long for an expanding waist or if not you can redo these steps to shorten it further.

 

Intellectual Property

Buckles: Our belt buckles are protected by U.S. Patent 10,932,529 B2